www.YamahaR.co.uk

Hi Mark
Choke & fast idling is fine - Throttle bodies needing balanced could be the issue

Fitted new Air intake sensor & Atmospheric air pressure senso…login to view the rest of this post

Hi There

Haven't balanced the throttle bodies on her yet - Will look into that

Thanks for the reply

Hi
Thanks for replying - Was beginning to think I was just talking to myself in here...!!! lol

The EXUP valves has been completely removed from the exh…login to view the rest of this post

Bike now running but not 100% yet

Fault codes 11, 13 & 20 where present on diagnostic screen/clocks upon diagnostic check
Code 11: Cylinder Identificat…login to view the rest of this post

Hi
Have found out that if you hold in the Reset & Select buttons on the dash clocks at the same time and switch on the ignition roughly 8 seconds later…login to view the rest of this post

Hi Mark
Thanks for replying bud

Where on the dash should it display the error code ? I can only see the flashing EML light at present

Have disconnected …login to view the rest of this post

Hi Folks
Went to start my R1 the other day and it started but cut out nearly instantly - Now EML light on and it wont start
Whilst its cranking over th…login to view the rest of this post

Not as yet
There is supposed to be a fuse box under the seat but I can't locate it
Is the fan relay behind the left hand headlight?

There is no temp sensor in the radiator there is a sensor beside the thermostat housing on engine and it's working fine - fan motor also fine
Temp gu…login to view the rest of this post

Hi Mark YVPS
Thanks for replying and all the great info will check that out
Thermostat working fine on the engine - engine not overheating unless stop…login to view the rest of this post

Why say that the yanks will need to know that on a UK Forum....?
I don't get that at all !

A 5PW is the model code for a 2002/3 years of a Yamaha YZF R1

Thanks for the reply

Hi there

Have a 2002 Yam R1 5PW with the following issues:
1. Engine idle speed too high - idling at 1300 rpm should be roughly 800, adjustment screw on…login to view the rest of this post

Hi All
Just joined today so Hello to everyone

I have just purchased a damaged 2002 5PW Yam R1 and I am in the process of putting it back to standard with a few tasteful mods
The bike was bought damaged with just cosmetic damage ie Fairings etc etc - The previous owner had started to street fighter ...