www.YamahaR.co.uk

I want to remove my rear footrest but does anyone know of any original or aftermarket parts that cover the holes in the frame and also hold the reservoir bottle on a 2013 R1, if so where can I get them

Re the holes, I just put some black insulation tape over them. Re removing the pegs you have to take the back end off the bike.

Re the holder for the reservoir I used the cross link thingy that holds both the foot pegs together, bolted it into the place of one of the pegs, needed a one inch spacer though and then got a small 90 degree bracket to hold the reservoir to it.

Good luck

Steve

use the search facility this has been covered before I think someone even made up some nice replacements

Luke03R1 wrote:use the search facility this has been covered before I think someone even made up some nice replacements

+1 covered again and again.

Taping up the holes, really bad advise if you believe the manufacturer of your bike that is

Get some black paint


Sent from my iPad using Tapatalk